Home/Product ranges/Hydraulics/Hoses and cable
Selection guideReels for hoses and cable
Replacing a combined reel or equipping a machine? Compare AG/E to A6/E according to the hydraulic lines and cable, or identify the equipped forklift kit.
Choose a family
Select the hydraulic lines and electrical configuration together. The number and cross-section of conductors must be checked for the same part number.
AG/E — two lines and cable
Two hydraulic lines and one cable; diameters from 1/4″ to 3/8″. Check conductors and connections together.
View part numbers
A3/E — three lines and cable
Three hydraulic lines and one cable; diameters from 1/4″ to 1/2″. Check conductors and connections together.
View part numbers
A4/E — four lines and cable
Four hydraulic lines and one cable; diameters from 1/4″ to 1/2″. Check conductors and connections together.
View part numbers
A5/E — five lines and cable
Five hydraulic lines and one cable; diameters from 1/4″ to 3/8″. Check conductors and connections together.
View part numbers
A6/E — six lines and cable
Six hydraulic lines and one cable; diameters from 1/4″ to 3/8″. Check conductors and connections together.
View part numbersSeparate option — the equipped forklift kit
Your constraints, your family
Compare the number of hydraulic lines, diameter and usable length, then the number of conductors and electrical specifications. Check the overall dimensions of the assembly.
On a small screen, scroll the table horizontally if necessary.
Compare travel, flow rate and width
These parameters must be checked for the same part number, with its hose/cable assembly and number of conductors.
Usable length. Check the combination of diameter, flange size and number of lines. Lengths from another family or a version without cable cannot be transferred automatically.
Flow rate. The values shown distinguish 40 l/min for three and four lines from 30 for five and six. Compare them with the conditions of each circuit.
Width and mounting. Check the drawing of the equipped part number: the number of conductors and hydraulic lines affect the bracket dimensions.
Check conductors and suffixes
The suffixes range from /E2 to /E12. Record the number and cross-section of conductors in the existing equipment. If spare capacity is required for future development, specify it in the quote request and check its effect on the hose/cable assembly, slip ring assembly and overall dimensions.
Two limitations: the twelve-conductor version is not available with a 1/4″ hose, and the cable cross-section follows the hose diameter — 1 mm² in 1/4″, 1,5 mm² above that.
Identify the electrical slip ring assembly
Electrical transmission uses a slip ring and brush assembly in the hub: 50 V and 5 A maximum, milliamp outputs and bus connections on request.
For a spare-part enquiry, include the slip ring assembly part number, wiring diagram and observed symptoms. A loss of continuity requires diagnosis; it does not on its own identify the component to replace.
Four lines with cable in 1/2″
For four lines in 1/2″ with an electrical line, see the A4/E configurations. Do not infer its available diameters from the A4 Standard without cable.
What to send for a quotation
- For a replacement: full part number, photograph of the nameplate and views of the existing installation.
- Number of hydraulic lines, diameter, flow rate, pressure.
- Number and cross-section of conductors, with any required spare capacity explicitly specified.
- Voltage and current, power or signal.
- Any fieldbus.
- Available width and mounting hole centres.
Quotations and technical advice on request.